重慶升降平臺在作業過程中遇到故障時應當掌握一定的判斷和檢修能力，例如電線及調壓閥發熱，細心的用戶會發現引起發熱的原因是不一樣的，下面就給大家詳細介紹一下電線過熱的原因有哪些？

1、絕緣套管使用不到位，系統發生短路故障，過電流使容量不足的接點或有缺陷的接點，發生瞬間冒火等，接點發熱主要是因為接觸電阻變大造成的。
Hangzhou freight elevators use the insulating sleeve is not in place, the system short-circuit fault, over current lack of capacity to make contacts or contacts defects occur instantly get angry, etc., the contact heat mainly because of high contact resistance caused.

2、接線盒沒有及時使用，長期運行的銅鋁接頭，接觸面沒有鍍銀或沒有掛錫的接頭，因接觸面產生嚴重電化腐蝕生成氧化膜，使接頭處電阻增大，極容易成為發熱點；平時流經小電流的接點，因系統突然變化，電流突增，導致接點發熱，及時使用接線盒可以預防此類問題的發生。
Hangzhou freight elevator did not use the junction box, aluminum joints, the contact surface is no long-running or no tin-silver-plated connector, due to exposure to severe galvanic corrosion surface oxide film, so that the joints resistance increases, very easy to become hot spots ; usually small current flows through the contact, due to a sudden change in the system, the current sudden increase, leading to joint fever, timely use of junction boxes can prevent such problems from occurring.

3、電線接頭處不使用絞接方法而是采用違章的彎鉤狀連接方法。
Hangzhou freight elevator wire joints without the use of a crossover method instead of using the hook-shaped connection method violation.